Dimensions for Fulton Replacement Bolt-On Mounting Kit # F500349
Updated 07/10/2018 | Published 07/06/2018
Question:
Can I get a few dimensions on the flange holes? I have attached an image. I should be able to extrapolate from these dimensions. thanks
asked by: Dan B
Expert Reply:
I went out to our warehouse to take a look at the Fulton Replacement Bolt-On Mounting Kit # F500349 referenced in your question. I measured a distance between the two outside bolt holes, horizontally, of right at 5-1/2 inches. Vertically the distance between two bolt holes is 1 inch and the distance between the top and bottom holes is just under 4-1/2 inches (4-7/16 inches to be exact).
I have attached an image with these dimensions labeled that you can also check out.
Product Page this Question was Asked From
Replacement Bolt-On Mounting Kit for Fulton XP Series Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Fulton
more information >
Continue Researching
- Q&A: Will Fulton XLT Trailer Jack Bolt to Same Bracket as FXP15W
- Q&A: Why Would Roof Rack with Fairing Still Whistle
- Q&A: Do Self Adjusting Trailer Brake Assemblies Need to be Initially Adjusted
- Q&A: How to Tighten Self Adjusting Brake Assemblies by Hand
- Q&A: Recommended Replacement Jack for Exiss Horse Trailer
- Q&A: Recommended Replacement Jack for Shelby Trailer Jack
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Replacement for Fulton Magnum Series Trailer Jack
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Lighting Requirements
- Article: Best Boat Trailer Jacks
- Article: How to Measure for Trailer Hitch Drop
- Article: Base Plate Adapter Table