Replacement Bearing Buddy Bras for Bearing Buddies with 2.13 Inch Outer Diameter
Updated 07/05/2018 | Published 07/03/2018
Products Featured in This Question
Question:
my buddy bearing measures 2.13..what do i need for a bra
asked by: Joan S
0
Expert Reply:
Based on your measurement of 2.13 inches it sounds like you will need model 19B # BB19B. These have an outer diameter of approximately 2-1/8 inches. They will be easier to put on if you leave them out in the hot sun for a little while. It makes them more pliable.
The next size up would be way too big and the next size down will be too small.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1781 - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.78 Inch
- 3000 lbs Axle
- Bearing Buddy
more information >
Continue Researching
- Q&A: Bearing Buddy for 1.98 and 2.13 Inch Trailer Hub Center Hole
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: How To Tell What Size Bearing Buddy Is Needed for My Trailer Hubs
- Q&A: How to Add Grease to Super Lube Trailer Hub with Rear Grease Zerk Fitting
- Q&A: Troubleshooting Weak Braking After Installing New Dexter Electric Brakes on Trailer
- Q&A: Trailer Hub Recommendation with 4 on 4 inch Bolt Pattern and Bearings L44643
- Q&A: How to Measure the Angle of Trailer A Frame To Determine if a 50 Degree A Frame Coupler will Fit
- Q&A: Difference Between Trailer Tire Sizes ST205/75R15 and ST225/75R15
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Lighting Requirements
- Article: How to Replace an RV Roof Vent Cover
- Article: How to Replace or Install an RV Roof Vent
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Accurately Measure Trailer Leaf Springs