Will Dust Cap Tool Work for Recessed Cap
Updated 07/03/2018 | Published 07/02/2018
Question:
Does the tool work for removal of a recessed cap? Please see photo.
asked by: Mark
0
Expert Reply:
The Dust Cap Driver Tool # 290-992 could work despite the recess you have. It measures just about 5" long so just be sure you have a bit more length than that or there is enough room for you to be able to maneuver the tool. Also keep in mind that this tool works for grease caps that have a 2.44" outer diameter.
expert reply by:
Kyle S
0
click to enlarge
Product Page this Question was Asked From
Dust Cap Driver Tool - Medium - for 2.440" OD Grease Caps
- Accessories and Parts
- Trailer Bearings Races Seals Caps
- Tools
- Driver
- Redline
more information >
Continue Researching
- Q&A: Solution for Needing Replacement Caliper for Kodiak 204 Caliper
- Q&A: Troubleshooting Grease Only Going Through Grease Zerk and Not Into Wet Bolt On MORryde # MR76ZR
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: What are the Correct Bearings, Races, and Seals for 4,400 Pound Axle?
- Article: Most Popular Wheel Bearings
- Q&A: Tool to Drive in 2.72" Hub Dust Caps
- Q&A: Bearing Kit that Fits Dexter 4,400 lb Axle of Alliance Delta 262RB
- Q&A: Replacement Grease Seal for Dexter 010-054-00 Seal
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule
- Article: Types of Bumpers
- Article: How to Tell the Weight Rating of a Trailer Axle