Replacement 2.72 Inch Diameter Grease Seal for a Trailer Hub
Updated 06/28/2018 | Published 06/26/2018
Products Featured in This Question
Question:
I need a dust cap for my axle. The other existing one measures 2.72”
asked by: Aaron
1
Helpful Expert Reply:
It sounds like you need a grease cap for your trailer hub. If this is the case then I recommend using part # RG04-120 if you have E-Z lube axles or part # RG04-100 if you do not. These caps are both press-in but if you have trouble then I recommend placing a rag over the cap and tapping it with a hammer very gently.
expert reply by:
Conner L
1
Product Page this Question was Asked From
Grease Cap, 2.72" OD Drive In with Plug - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- EZ Lube Grease Cap
- 2.72 Inch O.D.
- 2.72 Inch
- 6000 lbs Axle
- 7000 lbs Axle
- 8000 lbs Axle
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement 10-36 Dexter Grease Seal for 2022 Grand Design Reflection
- Q&A: Are Bearings Already Installed On TruRyde Trailer Hub and Drum Assembly
- Q&A: Recommended 7-Way Trailer Connector for a 2014 Ford F-150 w/out the Factory Towing Package
- Q&A: Replacement Grease Seals For TRP GS-1719DL
- Q&A: How Long is the DeeMaxx Trailer Wheel Lug Nut
- Q&A: What Size Socket is Needed for DeeMaxx Trailer Wheel Lug Nut
- Q&A: Which Timken Grease Seal for Trailer Hub Replaces GS-1719 DL
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Anti-Rattle Devices
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: How to Replace a Rubber RV Roof
- Article: How to Install an RV Awning From Scratch