96" Rubber Bumper Needed with Pre-Drilled Holes
Updated 06/09/2018 | Published 06/08/2018
Question:
Trying to find rubber bumper for horse trailer, with steel support bar. 8 foot long, 9 predrilled holes with 11 inch centers. Holes need to big enough to support 9/16 bolt with nut and washer.
asked by: Donald T
Expert Reply:
We have exactly what you are needing with part # D3-96 when it comes to the bumper. This is a pre-drilled round rubber trailer bumper that is 96" long (8') and has 9 holes drilled that as 11" apart on center and take 9/16" bolts. Unfortunately we do not carry any steel support bars with these specs so you would need to source that elsewhere.
Attached is an installation video for you to reference.
Product Page this Question was Asked From
Pre-Drilled Round Rubber Trailer Bumper - 96" Long x 3" Wide
- Trailer Door Parts
- Ramp Door Bumpers
- Bumper Strip
- Bolt-On
- 3 Inch Wide
- 96 Inch Long
- Rubber
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement for 84 Inch Bumper on Horse Trailer
- Q&A: Replacement Rubber Bumper For A Horse Trailer With A 81-1/2" Bumper Length
- Article: Trailer Wiring Diagrams
- Q&A: Does etrailer Sell The Rubber Bumper For Trailers D4-96 ?
- Q&A: What hardware is used to attach the 96inch predrilled rubber bumpers?
- Q&A: What Slide-Out Actuator will Replace My Kwikee with Part Number 907202104?
- Q&A: Will TowSmart T-Connector Wiring Harness Fit 2016 Chevy Colorado
- Q&A: Coupler Repair Kit for the Bulldog Gooseneck Coupler 028900
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Install E-Track in 3 Easy Steps