Grease Recommendation and Schedule for Dexter EZ Lube Spindles

Updated 06/06/2018 | Published 06/05/2018

Products Featured in This Question

LubriMatic LMX Industrial Strength Grease - 14 oz. Cartridge

(280)

$14.81

LubriMatic Deluxe Bearing Packer

(64)

$29.81

Question:

I have a 2012 Flagstaff Micro Lite 21’ with Torflex axles and Dexter EZ Lube that was just purchased last year what grease should I use for it and should I disassemble and remove existing grease first? Thanks

asked by: David M

Expert Reply:

Standard tapered trailer wheel bearings are recommended to be re-packed with fresh bearing grease about every year or every 12,000 miles under normal use. In certain conditions this interval could be shorter, such as if you routinely tow the trailer under conditions of extreme heat or near its maximum load capacity. This and other recommended trailer maintenance procedures are outlined in the linked article, which may interest you.

The best grease around for trailer hubs is the "Red" grease like the Lubrimatic LMX Industrial Strength part # L11390. It's waterproof, heavy duty, and compatible with most other greases as well.

Here's how to grease everything upon initial installation.

First, grease your bearings and spindle by hand or with a bearing packer like part # L70025. If you are going to do it by hand, start with a gob of grease in your palm and then press the bearing into the grease with some force.

Next, insert your bearings and grease seal in the hub and mount your hub on your spindle. You should slowly pump grease into the spindle. As you are pumping the grease into the spindle, occasionally rotate the hub. This will prevent the grease from building up in one spot.

Continue to pump grease until you begin to see the outer bearing move or you see grease seeping through the outer bearing. If you pump the grease slowly and rotate the hub, you should not blow the grease seal. Once you see the grease seeping through, you can install the washer, spindle nut and nut retainer. Keep in mind, when threading on the castle nut, you will want to tighten the nut until it is hand tight and then slightly back it off.