Replacement Braking Assembly for Offset Four Bolt Brake Mounting Flange

Updated 06/05/2018 | Published 06/02/2018

Products Featured in This Question

Dexter Electric Trailer Brakes - 12" - Left/Right Hand - 6K AL-KO/Hayes Axles

(1753)

$335.19

Dexter Trailer Hub and Drum Assembly for 5,200-lb Axles - 12" Diameter - 6 on 5-1/2

(1128)

$229.51

Question:

I need a brake assembly for an older trailer with Hammer Blow 6k lb axels that have the offset 4 bolt flange. The only break assembly I have found that would work with this bolt pattern is the Dexter 23-105-106-09. Two questions: Do you carry any other break assemblies that will work with my flange bolt pattern? Will my hubs work with this bake assembly? The current hubs are 12 inch. The brake pads on the old assembly are 2 inch. Three of the hubs have part number K-H85454. I don’t see a brand name. The other one doesn’t match. It is a Dexter hub with part number 8-201. Bearings on all of the hubs are 25580 and LM67048.

asked by: Darren

Expert Reply:

The Dexter Electric Brake Kit part # 23-105-106-09 is the only braking assemblies we have that will work with the offset four bolt brake mounting flange. The dimensions of these assemblies are 12" diameter x 2" wide therefore yes, will work with your existing drums. Unfortunately, the offset four bolt brake mounting flange is not very common so the list of compatible parts is very limited.

If you would like to replace the hub/drum instead of using you old ones then you will want to use the Dexter Trailer Hub and Drum Assembly part # 8-201-5UC3.

expert reply by: Conner L