How Far Out Does Emergency Handle for Bulldog Jacks # BD500187 and # BD500188 Stick Out
Updated 05/31/2018 | Published 05/29/2018
Question:
What is the horizontal measurement of the manual crank handle in case of a power failure. Basically how far it sticks out horizontally from the ion point of the jack to the handle for cranking. I have limited space due to the V-nose of my trailer.
asked by: Garth L
0
Expert Reply:
The crank handle part # BD500203 which is the replacement (and has the same specs) for both the Bulldog Powered-Drive Trailer Jacks # BD500187 and # BD500188 measures 8-1/2" from the center of the mounting shaft to the outermost part of the handle (see attached picture).
expert reply by:
Jon G
0
click to enlarge
Continue Researching
- Q&A: Replacement Electric Tongue Jack that Will Allow Full Opening of Tailgate on Tow Vehicle
- Q&A: Plate For Trailer Ramp Edge And Gap Between Floor And Ramp To Allow Wheels To Roll Without Catching
- Q&A: Electric Jack Wont Clear Tailgate on Truck.
- Q&A: Looking For Electric Jack That Can Be Rotated 90 Degrees
- Q&A: How Does The etrailer Electric Trailer Jack e55ZV Hold Up In Cold Weather?
- Q&A: Distance from Hitch Pin Center to Hitch Ball Center B and W Continuum
- Q&A: Troubleshooting Lippert Electric Jack That Will Not Extend
- Article: The Best Electric Trailer Jacks of 2025
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Determining Trailer Tongue Weight
- Article: Trailer Jacks
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Ball Mount Basics: Weight Capacity, Class, and Size