Measuring for Bolt Pattern on a 1961 Shasta Compact Camper
Updated 05/28/2018 | Published 05/26/2018
Question:
Measuring stud to stud, not diagonal, spacing is 3 1/4inch on center, would this be 4 on 4. Cant measure diagonal because of pilot sticking out on hud
asked by: Johnny S
Expert Reply:
Measuring center to center from a stud to one next to it on a 4 on 4 bolt pattern is about 2-13/16 inches. If you measured outside to outside it would around 3-1/4 inches. If you had 5 lugs at 3-1/4 inches center to center it would be a 5 on 5-1/2 bolt pattern.
To get a definite measurement I recommend measuring using the holes on the rim or removing the hub and measuring so you can measure straight across.
Product Page this Question was Asked From
Dexstar Solid Center Steel Wheel - 13" x 4-1/2" Rim - 4 on 4 - White Powder Coat
- Trailer Tires and Wheels
- Wheel Only
- 13 Inch
- 4 on 4 Inch
- Steel Wheels - Powder Coat
- Dexstar
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will a Hub Cap Work With Dexstar Solid Center Steel Wheel and Can It Be Painted
- Q&A: Solution for Needing Grease Cap for Hub Bore of 2.047
- Q&A: How to Determine if Wheel Trailer Setup is Hub-Centric or Lug-Centric
- Q&A: Recommended Wheel for a 1976 Rolco Tandem Boat Trailer with ST175/80D-13 Tires
- Q&A: Replacement Options for a 13 Inch Rim with a 2.5 Inch Diameter Pilot Hole
- Q&A: Replacement Wheels, Tires, and Bolts for a 4 on 9.44 Dexstar Vintage Steel Wheel
- Q&A: Correct Replacement for TDE 46210 Trailer Hub