Replacement Keel Roller Only or Keel Roller with Mounting Bracket
Updated 05/17/2018 | Published 05/16/2018
Products Featured in This Question
Question:
I need to replace the keel roller on my easy loader trailer. Roller is 1/2 way up, a bit toward bow. I do have self adjusting rollers mounted seperately on each side of the keel roller assembly. boat is 16foot Boston Whaler. Just roller or should I get with bracket ?
asked by: Allan
Expert Reply:
If your bracket is in good shape, not bent up or corroded then it is perfectly fine to replace just the roller with one of the same size. Roller # YR800Y has a 3-1/2 inch diameter at the widest point, it is 7-3/4 inches long overall, and fits a 5/8 inch diameter shaft.
If you do need or want to also replace the bracket I recommend # CE10453G which is already assembled and ready for install.
It is easiest and best to replace rollers while the boat is off of the trailer. That way you aren't putting additional stress on any other roller or support part of the trailer for an extended period of time.
Product Page this Question was Asked From
Yates Keel Roller for Boat Trailers - TPR - 8" Long - 5/8" Shaft
- Boat Trailer Parts
- Rollers
- Keel Roller
- 3-3/16 Inch Diameter
- Plastic
- 7-3/4 Inch Long
- Fits 5/8 Inch Shaft
- Yates Rubber
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Wheel Recommendation for Boat Trailer 175/80R13
- Q&A: Recommended Upgrade For 185/80D13 Trailer Tires That Had Blowout
- Q&A: Comparing PVC, TPR, and Polyurethane Boat Rollers
- Q&A: Replacement 6" x 2" Roller for Older Boat Trailer
- Q&A: Diameter of Ends of Dutton-Lainson # DL21728 Keel Roller
- Q&A: Self Centering Keel Roller for Tracker Trailstar Boat Trailer
- Q&A: Roller Shaft Dimensions for a 10" Keel Roller
- Article: How to Launch a Boat from a Trailer (And Load it Back Up)
- Article: Trailer Lighting Requirements