Installing Trailer Light Bar that Has Black and White Wires
Updated 05/09/2018 | Published 05/08/2018 >
Question:
I bought a new bar of lights for the back of my trailer the three in the middle it has a white and black wire but I only have one wire coming from the trailer how many am I supposed to have to hook up that light bar
asked by: Bill H
Expert Reply:
On your new light bar that features two wires like the Optronics # MCL922RB, the black wire should be for power, which will connect to the running light wire on the trailer. The white wire from the light bar will be for ground, which you will just need to attach to a clean, bare metal surface on the trailer frame.
Product Page this Question was Asked From
Identification Light Bar for Trailers over 80" Wide - Submersible - 3 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Light Bar
- Surface Mount
- Submersible Lights
- LED Light
- 15L x 1-1/2W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement ABS Hub for a Lippert 8,000 lbs Axle
- Q&A: Can A-60 Actuator be Locked
- Q&A: Availability of Red 328 LED Bullet Clearance Side Marker
- Article: Trailer Lighting Requirements
- Q&A: How Large of a Wire can I use with Large Body Chassis and Frame Clip - SWC9042-1
- Q&A: Universal 7-Way Trailer Connector to Use on a Custom Trailer
- Q&A: How to Replace Tie Down Engineering LP7000 Actuator
- Q&A: Will Aluminum Transition Plate Bend On Enclosed Trailer When Loading Heavy Zero Turn Mower?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Slipper Spring Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers


