Installation of Detail K2 Storm II Snowplow on a 2017 Ram 1500
Updated 05/03/2018 | Published 05/01/2018 >
Question:
I have found some retailers that have the crossbar to hookup the storm II plow to the vehicle mounting kit 84314-A. Your kit does not show the crossbar. Is that an additional item. This is my third message and Im sorry to keep bothering you guys. I have had excellent responses so far.
asked by: Dave
Helpful Expert Reply:
The Detail K2 Storm II snowplow, part # K2STOR8422, uses mounting brackets # K284314 on your 2017 Ram 1500. There isn't any trimming required for the install but it doesn't fit completely under either. Instead you need to completely remove the plastic air deflector from the bottom of the truck's bumper.
Product Page this Question was Asked From
Snowbear Storm II Snow Plow - Custom Mount - Winch Lift & Lower - 84" Wide x 22" Tall
- Snow Plow
- Vehicle Snow Plow
- Manual Angling
- 84 Inch Wide
- 22 Inch Tall
- Driveways
- Parking Lots
- Wireless Remote and In-Cab Switch
- Steel Cutting Edge
- Custom Mounting Brackets
- SnowBear
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Custom Mounting Brackets for Detail K2 Snow Plows
- Shop: Snowbear Storm II Snow Plow - Custom Mount - Winch Lift & Lower - 84" Wide x 22" Tall
- Q&A: Do Meyer Snow Plows Require Lots Of Hardwiring In Truck? What About Wireless Options?
- Q&A: Plow and Mount Recommendation for Installing K2 Detail Storm II on 2002 Ford F-150
- Q&A: Solution for Replacement Brake Pads for TDE 46304 Caliper
- Q&A: Difference in Detail K2 Snowplow for 2" Hitches and the Detail K2 Elite Snowplow
- Q&A: Recommended Front Hitch for a 2024 Toyota Tundra Hybrid TRD PRO
- Article: Trailer Wiring Diagrams
- Q&A: What Electrical Components are Needed to Install Detail K2 Elite Snow Plow
- Q&A: Will The SnowBear Snowplow K2AVAL8219 And Curt Front Hitch C31018 Fit A 2013 Ford F-250 4x4?
- Article: Thank you!
- Article: Best Bike Racks for Electric Bikes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: My Trailer Hitch Doesn't Fit
- Article: Rooftop Cargo Carriers


Dave
5/1/2018
I have found some retailers that have the crossbar to hookup the storm II plow to the vehicle mounting kit 84314-A. Your kit does not show the crossbar. Is that an additional item. This is my third message and Im sorry to keep bothering you guys. I have had excellent responses so far.