Tips for Installing EX1033 Hinge on Extang Trifecta Tonneau
Updated 04/20/2018 | Published 04/18/2018
Question:
Is there a technique to installing the hinge? I was able to get the old hinge out with a screwdriver but getting the replacement hinge in the groove of the cover is extremely difficult. I must be doing something wrong. Any advice would be greatly appreciated.
asked by: Dale
Expert Reply:
I emailed Extang for tips on installing the hinge part # EX1033 and this is what they sent back:
"The hinges should just slide into the rails of the cover. It is easier when the cover is folded open and you are putting both sides of the hinge in at once.
Please let me know if you need anything further."
Product Page this Question was Asked From
Replacement Tailgate Hinge for Extang Trifecta and eMax Tonneau Covers - Qty 1
- Accessories and Parts
- Tonneau Cover
- Hinges
- Extang eMAX
- Extang Trifecta
- Extang
more information >
Continue Researching
- Q&A: Troubleshooting A Furrion Range/Oven Knob That's Always Lit Up Red
- Q&A: Replacement Hinge Installation on Extang Solid Fold 2.0 Hard Tonneau Cover
- Q&A: Replacement Hinges For An Original Extang Trifecta Soft Fold-Up Tonneau Cover
- Article: How to Install a Weight Distribution Hitch (With Pictures & Video)
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: How To Reconnect the Rear Panel On An Extang Solid Fold 2.0 Hard Tonneau Cover
- Q&A: Sumo Springs Versus Shocks for Toy Hauler
- Q&A: Which Bumpers Can I Flat Tow a Jeep Wrangler JLU With Using D-Ring Adapters
- Q&A: Why Won't 7-Way Connector on Trailer Fit Factory 7-Way on My New Silverado
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: What are the Common Types of Propane Fittings Used on RVs?