How Long Does it Take to Install Roadmaster Base Plate Kit
Updated 04/10/2018 | Published 04/09/2018 >
Question:
Can you tell me about how much time it would take to in stall this on a 2010 Ford Escape .
asked by: Bruce D
1
Helpful Expert Reply:
Base plate kits are somewhat time consuming but they aren't too terribly long. I once asked our install guy that's been here forever how long to set aside for a base plate kit install and he said a "long afternoon" and you'd be good.
I attached a link to the install instructions for this kit down below for you to check out as well to give you an idea.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Roadmaster Direct-Connect Base Plate Kit - Removable Arms
- Tow Bar Base Plate
- Removable Draw Bars
- Hitch Pin Attachment
- Partially Hidden
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: chill cube
- Search Results: chill cube ductless
- Search Results: torklift truck camper tie downs
- Shop: Base Plate for Tow Bar
- Shop: Coleman-Mach Signature Mach 3 RV Air Conditioner System - Ductless - 13,500 Btu - Textured White
- Search Results: fridge
- Shop: Advent Air RV Air Conditioner - 13,500 Btu - Black
- Shop: Advent Air RV Air Conditioner - 15,000 Btu - White - R32
- Search Results: chill he
- Shop: Camper Tie-Downs
- Shop: Valterra RV Ceiling Vent w/ Dampers and Covered Screws - 5" Diameter - Light Beige
- Shop: Phoenix USA Baby Moon Hubcap - 12" Diameter - Stainless Steel - Qty 1
- Shop: Roadmaster Direct-Connect Base Plate Kit - Removable Arms
- Shop: Replacement Wooden Toilet Seat and Lid for Dometic Full-Timer RV and Sealand Toilets - White
- Shop: RV Mattress
- Q&A: Replacement For Truma DLE60C RV Water Heater
- Shop: RV Covers
- Q&A: Spring Bars for Reese Steadi-Flex Weight Distribution System
- Q&A: Compatibility of Curt and Reese Weight Distribution System Components
- Q&A: Can 1,200 lb Bar # RP66009 Replace 800 lb Bar # RP22225 for Reese Strait-Line WD System
- Q&A: Solution for Reese SC Weight Distribution Trunnion Bar Needing Replacement
- Q&A: Can Dual-Cam Sway Control be Added to an Older Reese Weight Distribution System
- Q&A: Is Noise and Slightly Bent Trunnion Bars Safe for a Weight Distribution System
- Search Results: rp66074
- Search Results: hitch ball w/ 1~1/4" diameter shank

