Recommended Water Heater Anode Rod with 3/4 Inch NPT Fitting
Updated 04/06/2018 | Published 04/05/2018 >
Products Featured in This Question
Question:
What is the size/threading of the plug? My hot water heater has a 3/4inch NPT plug that can be removed will this anode fit in that port?
asked by: Michael
0
Expert Reply:
The reducer bushing on the Camco RV Water Heater Anode Rod part # CAM11533 is a 1/2" NPT fitting. Please note that the outer diameter of the fitting is not the same as NPT. The outer diameter of the threads on a 3/4" NPT fitting is 1.060". For an anode rod with a 3/4" NPT fitting, the only option we have for you is part # CAM11563 which is 9-1/2" long.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Camco RV Water Heater Anode Rod w/ Drain - 1/2" Diameter x 4-1/2" Long
- Accessories and Parts
- RV Water Heater
- Anode Rods
- 1/2 Inch Diameter
- Magnesium Rod
- 4-1/2 Inch Long
- Camco
more information >
Continue Researching
- Q&A: Does the 30 Amp Go Power PWM Solar Charge Controller GP76QR Display Watts Produced?
- Q&A: Weight Distribution Recommendation for 2026 Jayco Feather 19MRK
- Q&A: Black Awnings for 7' and 15' Slide-Outs
- Q&A: Correct Solera RV Slide-Out Awning for 2017 Keystone Cougar 28RKS
- Q&A: Correct Solera RV Slide-Out Awning Measurements
- Q&A: How To Switch A MaxxAir MaxxFan Out Of Auto Mode
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Repair an RV Roof
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Drain an RV Water Heater
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control

