Parts Needed to Flat Tow 2006 Jeep Wrangler  

Question:

Expert Reply:

As long as the bumper on your 2006 Jeep Wrangler is rated for towing your vehicle you could use the # C19748 which comes with hardware to mount to it. With this kit you want to use the Curt tow bar # C19745.

A frame mounted base plate kit would be a better option that we know will work though. For that the Roadmaster EZ4 kit part # RM-521424-4 would be a great option. And then for a tow bar the part # RM-520 plus the safety cables part # RM-643.

For lighting you can use the diode kit, # RM-15267, and not have to worry about cutting into the taillight housing. This will splice into your taillight wiring to allow your tow vehicle to control the taillight assemblies of the towed vehicle. This comes with a round 6-way connector that you will install on the front of your towed vehicle and enough coiled wire to go from there to the RV.

And finally, most states now require supplemental braking in the vehicle being flat towed. The easiest system to set up and use is the Blue Ox Patriot # BLU37TR, that applies the vehicle brakes in proportion to how much the tow vehicle is braking. This is the safest way to stop and it reduces wear and tear on both vehicles.

Most likely you will also need a high low adapter so that the tow bar will be level when you are flat towing. I attached a link to a page that has all of the ones we carry.

I have included a couple of helpful links to our articles on flat towing for you. Be sure to consult the vehicle owners manual for more specific information on flat towing your vehicle.

expert reply by: Jameson C

0