What Wire Gauge Does Valterra EZ Valve Electric Waste Valve Use?
Updated 04/02/2018 | Published 03/31/2018
Products Featured in This Question
Question:
hi on the valterra electric waste valve it only comes with 7 foot of cable/wire from the valve to the switch can you tell me how many wires and what gauge the wire is Im a little fauther away then 7 also the power is two wire 3 1/2 foot long what gauge is this so i can get the power to there from the switch i will be ordering it all at the same time thanks
asked by: Vincent K
Expert Reply:
I spoke with a representative of Valterra who told me that the Valterra EZ Valve Electric Waste Valve # E40B-8 uses 3 wires, each of which are 18 gauge.
Please keep in mind that you will need ABS solvent bond # A05-0303 for installation of this valve.
Product Page this Question was Asked From
Valterra EZ Valve Electric Waste Valve for RV Black Water Tank - 3" Hub to 3" Hub
- RV Waste Valves
- Straight Valve
- Single Waste Valve
- 3 Inch Valve Body
- Electric
- 3 Inch Hub
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: Surge Protector for 2026 Thor Pasadena 34XG With 50A Service
- Q&A: Can Furrion Vision S+ Monitor Be Powered By USB
- Q&A: Can Valterra EZ Valve Electric Waste Valve Be Installed Sideways Under 5th Wheel Trailer
- Q&A: Best Complete Replacement For Kwikee 41 Series Double Step 904109000
- Q&A: Replacement Microwave for a High Pointe EM925AWW-B
- Q&A: What Is The Shoe In A Schwintek Slide Out System And What Does It Do
- Q&A: Troubleshooting Trailer Tire Wear on the Outside Edge of the Tire
- Article: Converting Your RV Water Heater to Tankless
- Article: What Does it Mean When an RV is Solar Ready?
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Can You Flat Tow a Ford Escape?
- Article: Dealer Spotlight - Hamilton Trailer Repair
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)