Can Pollak Toggle Switch # PK34212 Handle 25 Volts
Updated 03/30/2018 | Published 03/29/2018
Question:
The switch is rated at 12 volts. Will it operate properly at 25 volts?
asked by: Nick L
0
Expert Reply:
Pollak Heavy-Duty Toggle Switch # PK34212 is actually rated for 12 to 24 volt systems. If 25 volts is the peak for your application then it will likely work. If the constant voltage is 25 volts or higher than I would not recommend it.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Pollak Heavy-Duty Toggle Switch - SPST- On-Off - 12V DC - 50 Amp - 1" Handle
- Accessories and Parts
- Wiring
- Switches
- Toggle Switch
- 50 Amp
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Does Signal Booster for TST TPMS Come With Inline Fuse
- Q&A: How To Wire In Three Thermat Heat RV Tank And Pipe Heater Pads
- Q&A: How To Secure and Wire the ThermaHeat RV Holding Tank Pads
- Q&A: Replacement Tail Lights for a 2008 Featherlite 4926 Car Hauler Trailer
- Q&A: Does Signal Repeater of TST TPMS for RVs Have to Be Installed
- Q&A: Recommended Replacement Leaf Springs For Fifth Wheel Trailer
- Q&A: Is There an RV Tire Pressure Monitor System that Uses Internal Sensors
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Maintenance Schedule
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft