Replacement Bolt Recommendations for a # 24715 Draw-Tite Hitch
Published 07/28/2011
Question:
Do you sell the 3 bolts and 3 washers separately for mounting this Draw Tite hitch?
asked by: Martin T
0
Expert Reply:
You can get a hardware kit for your hitch if you get a Replacement Hardware Kit # RHK and then enter the part number for the hitch that you need when prompted to get the right hardware kit.
But if you wanted to run to the hardware store and pick up 4 M10 x 1.25 x 30 mm bolts and corresponding washers you would have everything you need to bolt up the Draw-Tite Sportframe Trailer Hitch Receiver # 24715 to your 2001 Toyota Camry.
I attached installation instructions for you to check out also.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Hardware Kit for Trailer Hitches
- Accessories and Parts
- Trailer Hitch
- Hardware
- etrailer
more information >
Continue Researching
- Q&A: How to Eliminate Sag When You Have a Weight Distribution Hitch Installed Already
- Q&A: How To Order Replacement Hardware Kit For Curt Trailer Hitch
- Q&A: Looking For Install Hardware For Draw-Tite Hitch On 2025 Ford Maverick
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Curt Hitch #13408 Replacement Hardware Recommendation
- Q&A: Getting Replacement Hitch Install Hardware for GM Hitch for 2005 Chevy Silverado 2500HD
- Q&A: Replacement Hardware Kit for a Curt C13382 Hitch
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Hitch Installation Tips
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: How to Measure for Trailer Hitch Drop