Why is One Set of Front Timbren SES # TTOFTUN4 Installed on a 2005 Toyota Tundra w/ 4 Bump Stops
Updated 03/29/2018 | Published 03/27/2018
Question:
Why only one timbren is installed per side when there are two front bumpers per side?
asked by: Kyp
Expert Reply:
If you check out the linked installation details for the Timbren Front Suspension Enhancement System # TTOFTUN4 that you referenced you will note that they say to remove the rearmost bump stop (for the front suspension). You will not be replacing all 4 of them, only 2. This is because there is only room for one upgraded bump stop.
Please note that any suspension enhancement will not increase the weight capacity of your 2005 Toyota Tundra. It is only meant to support a suspension that is in good working order.
I have linked a review video for you to check out as well.
Product Page this Question was Asked From
Timbren Front Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Extra Heavy Duty
- Front Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Timbren Rear Suspension Enhancement Recommendation for 2023 Toyota Tacoma
- Q&A: Comparing Timbren Suspension Enhancement for 2018 Toyota Tacoma
- Q&A: Will Hellwig EZ-1000 Helper Springs Fit 4X4 1991 Toyota Pickup
- Q&A: Recommended Spacers for a Firestone Ride-Rite Air Bag Kit
- Q&A: What Suspension Upgrade do I Need for My 2025 Tundra with In-Bed Camper?
- Q&A: Recommended Timbren Front Suspension Enhancement System For a 2017 Toyota Tundra With Snow Plow
- Q&A: How to Install the Timbren Front Suspension Enhancement System on a 2016 Toyota Tundra
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Determine Tire/Wheel Diameter