Replacement 7-Way and Wiring Diagram for Camper
Updated 03/20/2018 | Published 03/17/2018
Question:
Someone cut the pigtail off my camper where you plug into the bumper of the vehicle for the brake lights ,marker lights ,etc of the camper to work . How can I get a schematic to camper for the correct wiring of a 7 pin connector ?
asked by: Hubert C
0
Expert Reply:
Sorry to hear about the vandalism of your camper. I attached a couple diagrams for 7-way trailer wiring harnesses. For a replacement 7-way we have the part # H20042 which comes with 3 feet of wire.
expert reply by:
Jameson C
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
7-Way Molded Trailer Wire Connector - 3' Long
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 7 Blade
- Plug and Lead
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Looking For Replacement Pins For etrailer Adjustable Ball Mount e66PR
- Q&A: Looking For Locking Pins For etrailer Adjustable 2-Ball Mount e66PR
- Q&A: Recommended Hitch Ball For Fastway e2 Weight Distribution
- Q&A: Replacement Bearings, Races, Seal, and Studs for Trailer Hub 008-479-05
- Article: Trailer Wiring Diagrams
- Q&A: Dexter Brake Assembly Recommendations to Replace Part Number 023-357-00
- Article: How Much Weight Can I Put on My Trailer Hitch?
- Q&A: How to Find Correct Replacement Hubs for Shorelandr Boat Trailer
- Q&A: Weight Distribution Comparison Of A Blue Ox SwayPro And A Reese Straight-Line
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Hitch Balls
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision