Dimensions of Dexter Electric Brake Adjuster Spring

Question

Question:

Can you give me the dimensions of this spring?

asked by: Ryan P

0

Expert Reply:

I went to our warehouse to measure the Replacement Adjuster Spring for Dexter Electric Brake Assembly # BP08-155 for you. The length of the spring is 4.14 inches and the width is .43 inches. I've attached a photo to assist.

expert reply by: Jason S

0

click to enlarge

Answer 1

I may have a solution for you, but I'm not aware of a bearing that has the L44640 number. However, the Replacement Trailer Hub Bearing - L44649 #L44649 is a fairly common bearing found in trailer hubs and has an inner diameter of 1.063". If…

view full answer...

Answer 2

The #BP08-070 measures 4 inches in length. The coiled portion of the spring is 1-5/8 inches in length and 13/16 of an inch in diameter. I've provided a photo showing these dimensions. This spring is the correct length to replace your existing…

view full answer...

Answer 3

Hey Bill, based on your brake assembly size the correct replacement adjuster spring would be the part #046-083-01 which is the size you mentioned needing.

view full answer...

Answer 4

For the complete brake assemblies, you would want the Titan Hydraulic Brake Kit - Uni-Servo - 12" - Left and Right Hand Assemblies - 6,000 lbs #T2351100-000. For the wheel cylinder replacements you will want the right hand #AKBRKR-H7-R and left…

view full answer...

Answer 5

It sounds like you're looking for an adjuster spring and in which case we do carry this, the Replacement Adjuster Spring for 10" x 2-1/4" Hydraulic Trailer Brakes part #046-083-01 which works on both Dexter and Demco hydraulic trailer…

view full answer...

Answer 6

We do indeed, the #BP10-060 brake adjuster for 10 or 12 inch hydraulic brake assemblies fits Dexter, Demco and Dico 10" Hydraulic trailer brake assemblies, so it would work great for you. If you also need a new adjuster spring, use #046-083-01

view full answer...

Answer 7

It sounds like you're looking for a brake adjuster spring for your 10" brakes, so you can use the Replacement Manual-Adjuster Spring for 10" and 12" Electric Trailer Brake Assemblies #BP08-070; this part is 4-1/8" long. There…

view full answer...

Answer 8

The overall length of the spring part #BP08-070 that you referenced is 4-1/8 inches.

view full answer...

Answer 9

It looks like you need Replacement Adjuster Spring for Dexter Electric Brake Assembly #BP08-155, but you can measure to verify. This measures 4.14" long and .43" wide. You may need to bend your old spring back in order to get an accurate…

view full answer...

Answer 10

Your trailer must have free backing brakes if you have never used the surge brake actuating coupler reverse lockout. If you did not have free backing brakes, your brakes would most likely brake even if they didn't lock up when you back up because…

view full answer...

Answer 11

If a tandem axle trailer only has one braking axle it will typically be the front axle. If you are looking to add an axle I recommend that you check with your local laws regarding trailer weights and braking axle requirements. Not all states allow…

view full answer...

Answer 12

We do sell just the adjuster springs for drum brakes; you can see the springs for 10-inch electric and hydraulic drum brakes on the linked page. For a 10-inch AxleTek electric drum brake you can use Dexter part #BP08-070 which fits both 10-inch and…

view full answer...

Dimensions of Dexter Electric Brake Adjuster Spring

Product Page this Question was Asked From

Continue Researching