Will the Kodiak Disc Brake Kit Part # K2R1058D11 Fit a Dexter 10k General Duty Axle
Updated 02/26/2018 | Published 02/24/2018
Products Featured in This Question
Question:
will this work on A dexter 10K general duty axle
asked by: Punky
Helpful Expert Reply:
Yes, the Kodiak Disc Brake Kit part # K2R1058D11 will work with your Dexter general duty 10,000 lb axles as long as you have an 395S inner bearing (2.625" inner diameter) and 387A outer bearing (2.250" inner diameter). These brakes are only compatible with a specific type of hub which is the two piece Dexter 8-288. If you also need the hub then you can use the Dexter Trailer Idler Hub Assembly part # 8-214-5UC1.
I have attached a review video of the hub for you as well.
Product Page this Question was Asked From
Kodiak Disc Brakes - 11" Rotor - 8 on 6-1/2 - Raw - Leaf Spring - 10K Dexter and Lippert
- Trailer Brakes
- Disc Brakes
- Standard Grade
- 8 on 6-1/2 Inch
- Rotor
- 10000 lbs Axle
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- 17 Inch Wheel
- 17-1/2 Inch Wheel
- Kodiak
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Select Replacement Hub with Bearings, Races and Seals
- Q&A: Replacement Grease Seal for a 168255TC Rubber Coated Seal
- Q&A: What Grease is In etrailer Pre-Greased Trailer Hubs
- Q&A: How To Convert Dexter Electric Drum Brakes to Hydraulic Disc Brakes on 10K Axle
- Q&A: Trailer Brakes are Very Weak Even After Adjusting Them
- Q&A: How to Install a Brake Controller on a 2015 International 7400
- Article: How to Measure a Trailer Axle
- Q&A: What Size Socket Does the Dexter Dual Trailer Wheel Lug Nut with Swivel-Flange Use
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012