Can the Camco RV Water Heater Anode Rod # CAM11533 be Used with a 3/4" to 1/2" Bushing
Updated 02/19/2018 | Published 02/17/2018
Products Featured in This Question
Question:
Will the Camco 11533 rod work in a Suburban water heater if I use a 3/4 to 1/2 bushing?
asked by: Bob B
0
Expert Reply:
The Camco RV Water Heater Anode Rod # CAM11533 that you referenced can be used with a bushing for your Suburban water heater. My contact at Camco confirmed this.
When I spoke with my contact at Camco he did say that if your Suburban water heater is a 10 gallon then you would be better off to go with the Camco RV Water Heater Anode Rod # CAM11563 instead which already has a 3/4" diameter.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Camco RV Water Heater Anode Rod w/ Drain - 1/2" Diameter x 4-1/2" Long
- Accessories and Parts
- RV Water Heater
- Anode Rods
- 1/2 Inch Diameter
- Magnesium Rod
- 4-1/2 Inch Long
- Camco
more information >
Continue Researching
- Q&A: Does the 30 Amp Go Power PWM Solar Charge Controller GP76QR Display Watts Produced?
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Q&A: Replacement Bearing and Seal for 5,100 lb Trailer Axle
- Q&A: Weight Distribution Recommendation for 2026 Jayco Feather 19MRK
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Does Andersen Weight Distribution Hitch Have More Or Less Noise Than Friction Style Equalizers?
- Q&A: How Does Andersen Weight Distribution Reduce Sway Without Friction Bars?
- Q&A: Comparing the Andersen Weight Distribution Systems To Friction Bar Systems
- Article: How to Repair an RV Roof
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Drain an RV Water Heater
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control