Height of Rubber Spring in Timbren Spring Kit # TJFTJ
Published 02/13/2018
Question:
I have a 2009 wrangler that is suspension lifted 3.5 and I have a western midweight plow on it. I need to stiffen up the front will tfhese work with my lift kit? I noticed someone mentioned needing enough spacers to retain a 1/2 inch gap between timbren and axle. If thats the case what is the length dimensions of the timbren itself so j can find out how much of a spacer I need.
asked by: Matt S
0
Expert Reply:
I spoke to my contact at Timbren and they informed me that the height of the rubber spring of the Timbren kit part # TJFTJ is 3-15/16 inches.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Timbren Front or Rear Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Standard Duty
- Front Axle Suspension Enhancement
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Suspension Enhancement
- Shop: Timbren Front or Rear Suspension Enhancement System
- Q&A: Recommended Timbren Front Suspension Enhancement on 2013 Jeep Wrangler Unlimited with Snow Plow
- Q&A: Would a Timbren Suspension Enhancement System be able to Replace a Weight Distribution
- Q&A: Will SumoSprings Coil Helpers Fit Front And Rear Axle Of 2023 Jeep Wrangler JKU
- Q&A: 1999 Casita Travel Trailer 16 Spirit / Door Lock Replacemant Recommendation
- Q&A: Life Span Of Dexter Torsion Trailer Axle On a 2000 Casita Travel Trailer And Replacement Axle
- Q&A: Hardware Needed to Install Timbren Spacer with Suspension Enhancement System on 2013 Ram 1500
- Q&A: Are Front Coil Spring Helpers Recommended for Towing on 2010 Ford Expedition?
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Best RV Roof Vents