Bolt Pattern of Dutton-Lainson Drop Leg Jack Part # DL22320
Published 07/07/2011
Question:
I was looking for the bolt pattern for the Dutton Lainson Trailer Jack, p/n: DL22320. Specifically the width from side to side. Thank you.
asked by: SNIPES
0
Expert Reply:
The bolt holes on the mounting plate of the Dutton-Lainson 2500 lb Drop Leg Trailer Jack, part # DL22320 measure 5-1/2 inches apart, measured center to center. Each of the top three holes is 1 inch apart from the row below it.
expert reply by:
Mike L
0
click to enlarge
Product Page this Question was Asked From
Dutton-Lainson Trailer Jack w/ Footplate - Sidewind - Fixed Mount - 15" Lift - 2,500 lbs
- Trailer Jack
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Sidewind Jack
- 2001 - 3000 lbs
- Manual Jack
- 28 Inch Lift
- Weld-On
- With Rectangle Foot
- Dutton-Lainson
more information >
Continue Researching
- Q&A: Will etrailer Swivel Jack w/ Bolt-On Mounting Plate Work On Restored Rental Trailer
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Q&A: Bolt-On Swivel Jack Options for 6" Tall Trailer Frames
- Q&A: Good Replacement Trailer Jack For Older Shelby 5756 Side Wind Snap On Jack
- Q&A: Diagram of a 10k Bulldog Landing Gear Jack for Gear Replacement
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: What is Amp Draw of the Motors of the Happijac Electric Camper Jack
- Q&A: Replacement Mounting Brackets For HappiJac Electric Truck Camper Jack System
- Article: Gooseneck to 5th Wheel Adapters
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)