Installation Instructions for the Edge Insight CS2 # EP84030
Published 01/26/2018
Question:
How hard is it to Wire or plug in
asked by: Matt
0
Expert Reply:
The Edge Insight CS2 # EP84030 is a fairly easy install. The most difficult part is routing the wire from the OBD-II port under your vehicle up to your windshield. After that you will just need to attach the window mount to the window and then install the gauge display itself.
As you can see from the attached photo that I snapped of the installation instructions, the wiring can easily be routed on most vehicles by simply removing the side panel.
I have attached a link to the installation instructions for you to check out as well.
expert reply by:
Jon G
0
click to enlarge
Product Page this Question was Asked From
Edge Insight CS2 Comprehensive Gauge Display - Color Screen
- Performance Chip
- Monitors
- Color Screen
- Yes - California Approved
- Insight
- Edge
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Best Air Bag Kit For 2026 Ram 3500 With In-Bed Hitch
- Article: Performance Chips and Modules
- Q&A: Parts Needed To Install 7-Way On a 2013 Chevrolet Express 2500 Passenger Van
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Anti-Rattle Devices
- Q&A: Trailer Hitch and Wiring for a 1997 Dodge B3500 Full Size Van
- Article: Rooftop Cargo Carriers
- Q&A: What Rear Anti-Sway Bar Fits a 2014 Chevy Silverado 2500 w/o a Factory Sway Bar?
- Article: How to Measure for Trailer Hitch Drop
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Is there a Gooseneck Hitch for a 2024 Ram 2500 w/out the Factory Prep Package?
- Q&A: Hitch and Wiring that Will use the Factory 7 and 4 Way Plug on the Bumper for 2019 Toyota Tacoma
- Q&A: Trailer Hitch Receiver for 2019 Toyota Tacoma With 2.7L Engine
- Article: 5 Things to Know About Weight Distribution Hitches