Recommended Wiring Connectors To Avoid Soldering with Replacement Switch for Husky Brute Jack
Published 01/18/2018
Question:
how do you chg the switch with out sautering the wires back on i already purchased the switch from e trailor i just need to know how to change the switch with the new one
asked by: Roy A
0
Expert Reply:
If you don't wish to solder the wires onto your replacement switch, you can use the Female Spade Terminal Quick-Disconnects like # DW01899-1 to give you quick connections you can crimp onto the wires.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Female Spade Terminal Quick-Disconnect - 16-14 Gauge - Fully-Insulated PVC - Qty 1
- Wiring
- Wire Connectors
- Quick Disconnects
- 14 Gauge
- 16 Gauge
- Deka
more information >
Continue Researching
- Q&A: What Is The Amp Draw For The Peterson LED Clearance/Side Marker/Third Brake Light PET75PV?
- Q&A: Will ThermaHeat RV Holding Tank or Step Heater Pad Help With Cold Weather Camping
- Q&A: Replacement Triple Switch Panel with SPST and SPDT Switches
- Q&A: Solution For A Fan-Tastic Fan 7300 Series That's Remote Is Not Working Or Pairing
- Q&A: Replacement Bathroom Vent for 2019 Lance 2185 Travel Trailer
- Q&A: What is the Difference Between Fan-Tastic Upgrade Kit FV807357 and FV807359
- Q&A: Difference Between Fantastic Fan Upgrade Kits FV807357 and FV807359
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Replace an RV Roof Vent Cover