Block Heater Installation on a 2017 Mazda 3
Published 01/18/2018
Products Featured in This Question
Question:
i intend to buy that part: ......Kats Heaters Custom Engine Block Heater - Frost Plug Style - 120V - 400 Watts - 3/4inch NPT Item # KH11409...... is there any picture and/or location on the engine where to install it ??? thanks
asked by: Sylvain
Expert Reply:
The Kat's Heaters Custom Engine Block Heater part # KH11409 is a confirmed fit for your 2017 Mazda 3 with either the 2.0L I4 or 2.5L I4 engine. The correct location in which the heater will need to be installed is on the driver's side of the engine in the lower left hand corner shown as "RL" in the attached photo. You will need to first remove the factory frost plug in order to install the element.
Don't forget the Kat's Heaters Plug Cover for Power Cords with 3-Prong Plugs part # KH28405 to cover the plug while not in use.
Product Page this Question was Asked From
Kat's Heaters Custom Engine Block Heater - Frost Plug Style - 120V - 400 Watts - 3/4" NPT
- Vehicle Heaters
- Engine Block Heater
- Frost Plug Style
- 400 Watts
- CSA Approved
- Kats Heaters
more information >
Continue Researching
- Q&A: Recommended Engine Warmer for a 2016 Ford Focus with 2.0 Engine
- Q&A: Install Instructions for Kat's Block Heater KH11409
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Largest Available Battery Heater
- Article: Which Hitches are Made in the USA
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Kat's Heaters Lower Radiator Hose Heater Size Availability
- Q&A: Towing Mirror Fitment For A 2024 Jeep Grand Cherokee Limited
- Q&A: Will the Cipa # CM10000-2 Mirrors Fit a 1993 Chevrolet Van
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)