Do Nev-R-Lube Bearings Last a Long Time

Question

Question:

What is the life expectancy of these never Lube bearings.

asked by: Mark

1

Helpful Expert Reply:

Dexter Nev-R-Lube Bearings such as the 50MM # 31-71-3 do not have a specific maintenance or replacement schedule. These are pre-lubricated at the factory, which will make it resistant to contamination, and sealed for life so there is typically no bearing maintenance needed. In nearly all cases they last the life of the trailer.

expert reply by: Jameson C

1

Answer 1

Dexter Nev-R-Lube Bearings such as the 50MM #31-71-3 referenced in your question do not have a specific maintenance or replacement schedule. These are pre-lubricated at the factory, which will make it resistant to contamination, and sealed for life…

view full answer...

Answer 2

I believe you're looking for the Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459. This is the same thing you're referencing in your question, measures 12" diameter x 2" wide, and fits 6,000 lb axles with 14 1/2" to…

view full answer...

Answer 3

Thank you for the picture which allows me to confirm the correct parts. Your Dexter D52 axles under your 2018 Coachmen Freedom Express Blast 271BL toy hauler came with the Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459. We do have the…

view full answer...

Answer 4

Thank you for the images. This shows me you currently have the Dexter Electric Trailer Brake Kit #23-105-106 on your 2007 Airstream Safari. I recommend upgrading to the Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459 as this will give you…

view full answer...

Answer 5

Hey Mitch, I would recommend the Furrion Chill Cube kit part #FR69TD which is a complete kit that includes a new air box, remote, and thermostat. This will give you the quietest system out there that is also the coldest blowing and draws least amount…

view full answer...

Answer 6

The part number you gave is no longer a valid number for Bulldog jacks. It sounds like you are looking for the Bulldog Square Jack w/ Footplate - Drop Leg - Sidewind - 15" Lift - 5,000 lbs #BD190754. This has a 5,000 lb lift capacity and an…

view full answer...

Answer 7

Dan, they won’t. The Dexter 7K ABS brakes #DX69WR / #DX79WR are specifically designed for Dexter Tow Assist axles - the flange offset and ABS tone ring position are unique to Dexter’s design. On Lippert 7K axles, the sensor alignment won’t match, so…

view full answer...

Answer 8

Hey Michael! When you're choosing a weight distribution hitch the most important factor is the tongue weight of the trailer. It looks like the dry/unloaded tongue weight of a Brinkley Z Air 297 is 924 lbs. Once you add batteries and propane you…

view full answer...

Answer 9

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 10

Hello Chase, thanks for reaching out. I have heard of the Solera Gas Struts like part #LC280343 working for the Stabilus Lift-O-Mat awnings. It is made for Lippert/Solera branded awnings, but some parts may be cross compatible. You would just need to…

view full answer...

Answer 11

The choice of oil bath or regular hubs is up to the manufacturer. They are usually found on higher capacity axles, though as you know there are some on lower capacity axles. You can convert some hubs from grease to oil bath using a kit such as…

view full answer...

Answer 12

Yes you can go the route you mentioned. You'd need to install an idler Dexter 8k Nev R Lube hub with part #004-402-90 on your spindles and then you could use a slip on kit like the part #K71-635-90 and you'd be set.

view full answer...

Do Nev-R-Lube Bearings Last a Long Time

Product Page this Question was Asked From

Continue Researching