Curt Trailer Hitch # 13053 Bolt Hole Dimensions
Updated 06/17/2011 | Published 06/15/2011
Products Featured in This Question
Question:
How widt is from side by side between holes close to the bumper Thanks
asked by: Adrian
Expert Reply:
This hitch measures 38 inches from bolt hole center to bolt hole center on all of the holes except for the rear most set of holes. These are 39-1/2 inches in width.
Check out the picture I attached to see this measurement.
You may be interested in the following products to complete your towing setup:
Tow Ready Custom Fit Vehicle Wiring # 118344 (instructions attached)
Ball Mount 1 inch Rise or 2 inch Drop # C45030
Hitch Ball with 2 inch Diameter and Medium Shank # 19247
Hitch Ball with 1-7/8 inch Diameter and Medium Shank # 19260
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 7500 lbs WD GTW
- 2 Inch Hitch
- 750 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Hitch for a 2016 E-450 Cab and Chassis
- Q&A: Trailer Hitch that Fits 2021 Lexus RX 350 F-Sport
- Q&A: Will Buyers Products Class 4 Service Body Long Hitch Receiver Fit 2018 Coachmen Pursuit Motorhome
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Lighting Requirements
- Q&A: Measurement of Curt 3-Piece Trailer Hitch C15511 from End of Mounting Flange to Receiver Tube
- Q&A: Recommended Hitch for a 2010 Thor Hurricane 32A on a Ford Chassis
- Q&A: Recommended Hitch for RV/Motorhome with 2004 Ford E-450 Van Chassis
- Q&A: Overall Width of Buyers Products Class 4 Service Body Long Hitch Receiver # 3371801055
- Article: Trailer Wiring Diagrams
- Article: What Do I Need To Tow A Trailer?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop