Will Camco Stack-A-Plate Plate Holders Hold 10-1/4 Inch Plate
Published 11/16/2017
Question:
Have a plate that's 10-1/4 will this work?
asked by: Robin
0
Expert Reply:
The Camco Stack-A-Plate Non-Slip Plate Holders # CAM43601 referenced in your question includes two different size plate holders. The larger of the holders can fit plates of up to 10-1/4 inches, so should work perfectly for the plate that you mentioned. The smaller holder can hold plates up to 7-1/4 inches.
I have attached a short video demonstration on this product that you can also check out.
expert reply by:
Chris R
0
Product Page this Question was Asked From
Camco Stack-A-Plate Non-Slip Plate Holders - Qty 2
- Kitchen Accessories
- Storage and Organization
- Plate Holder
- Camco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Hitch Mounted Cargo Carrier Information
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Q&A: SnapPad Kit Recommendation for a Truck Bed Camper with Happijac Jack System
- Q&A: Do You Have Snap Pads for Happijac Truck Camper Jack Systems?
- Article: Trailer Wiring Diagrams
- Q&A: What Is Length Of SP01-040 U-Bolt
- Q&A: Recommended Axle-Less Suspension System for M1101 Military Trailer
- Q&A: Is There a Plug-In Adapter for a 2023 Nissan Pathfinder With Factory Tow Package
- Q&A: Floor Mats For 2021 Newmar Bay Star Motorhome
- Q&A: Troubleshooting A Leaking MaxxAir MaxxFan In A 2021 Forest River Rockwood Mini Lite Travel Trailer
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Replace or Install an RV Roof Vent