Could Replacement LED for Tow-Rax Recessed Lights Fit Flood Light Buckets of Haulmark Trailer
Updated 11/13/2017 | Published 11/12/2017
Question:
I currently have 2 halogen flood lights on the outside of my Haulmark trailer. These lights tend to go through bulbs due to I believe the abuse they see when driving down the road. Would this light be something I could swap into my already existing housings?
asked by: Jordan
Expert Reply:
The Replacement LED for Tow-Rax Recessed Lights # TWPWLS110V50W that you referenced most likely would work fine on your trailer that has flood light buckets already installed in it. This is designed to fit internal bucket dimensions of 10-5/8" wide x 9-5/8" high x 5-5/8" deep which is a very standard size. I can't see why it wouldn't fit but I'd recommend you check out the dimensions of your flood light buckets and make sure they are the same or very similar.
Product Page this Question was Asked From
Replacment LED for Tow-Rax Recessed Lights - 50 Watts - Qty 1
- Accessories and Parts
- Trailer Lights
- Light Modules
- Clear
- Tow-Rax
more information >
Continue Researching
- Q&A: Recommended Exterior Light For An Enclosed Trailer That Runs Off Of 110V
- Article: Trailer Wiring Diagrams
- Q&A: Low Voltage on 7-Way of 2017 Ford F-250 Super Duty
- Q&A: Troubleshooting Trailer Brake Module Fault on 2008 Ford F-250 w/ a Factory Controller
- Q&A: How to Install 12V Battery Isolator to Prevent Vehicle Battery Drainage by Trailer Battery
- Q&A: How to Bypass Smart Tow Feature of Ford Trailer Wiring for 12 Volt Accessory Circuit
- Q&A: Replacement Dexter Brake Assemblies for 36-19 Assemblies
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Q&A: What Trailer Hitch Will Fit The 2024 Honda CR-V Hybrid
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers