Will Rear Bumper Cover of 2013 Buick Enclave Reinstall After Curt Hitch # 13424 is Installed
Published 11/10/2017
Question:
I have a 2013 Buick Enclave. Will the plastic bumper cover fit after hitch is installed?
asked by: Edward
0
Expert Reply:
Yes, when installed on a 2013 Buick Enclave the Curt Hitch part # 13424 will allow the rear bumper cover to be reattached and the hitch will not be visible.
Check out the install video I attached for more info as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What to do if Bolts Seem Too Large to Install Hitch on 2017 Buick Enclave
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Timbren Silent Ride Suspension for 2023 Grand Design Solitude 390RK
- Q&A: What Does etrailer Trailer Hitch e36AR Fit
- Q&A: Does the Kuat NV 2.0 Work with Bikes with Fenders?
- Q&A: How to Replace Tie Down Engineering LP7000 Actuator
- Article: Determining Trailer Tongue Weight
- Q&A: Dirt Bike Carrier With Car Tow Dolly on Class C Motorhome
- Q&A: Can Bike Rack be Used in Front Hitch of Truck
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)