Where are Draw-Tite Trailer Hitch Receivers Manufactured 2013 Honda CR-V
Published 11/03/2017
Products Featured in This Question
Question:
Where is the draw-tite hitch 75742 manufactured? Thank you.
asked by: Larry
Expert Reply:
All of the Draw-Tite trailer hitch receivers are made and manufactured in Mexico. For a trailer hitch receiver made and manufactured in the U.S.A. you would want to use a Curt hitch. The Draw-Tite Max-Frame Trailer Hitch Receiver part # 75742 is a confirmed fit for your 2013 Honda CR-V. For a Curt hitch that also fits your 2013 Honda CR-V, I reccomend using the Curt Trailer Hitch Receiver part # C13119.
I have attached an installation video of each hitch installed on a similar 2013 Honda CR-V for you as well.
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Hitch for a 2013 Honda CR-V
- Q&A: Parts Needed For Flat Towing A 2012 Honda CR-V
- Article: How to Choose the Right Trailer Hitch Class
- Article: Best Bike Racks for Electric Bikes
- Q&A: Tankless Water Heater Replacement Upgrade For A Suburban SW6DEL Water Heater
- Q&A: What License Plate Holder do I Want for My Cargo Carrier?
- Q&A: Trailer Hitch Receiver for 2015 Mercedes-Benz Sprinter with 170 Wheel Base and Factory Step Bumper?
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Holiday 2025 | Best Gifts for RVing
- Q&A: Replacement Hardware For a Curt Trailer Hitch Receiver # C13119 to Fit a 2013 Honda CR-V
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop