Availability of Replacement Screw for Fulton Magnum 2,500 lbs Trailer Jack
Updated 10/31/2017 | Published 10/30/2017
Question:
can i get a replacement acme screw shaft for this jack fulton 2500 magnum heavy duty
asked by: Paul
Expert Reply:
Fulton does not have a replacement screw for your Fulton Magnum 2,500 lbs trailer jack and it is not a good idea to use a different screw for a Fulton jack unless you know that it will operate the exact same way with the exact same ratios.
I recommend replacing your Magnum with the etrailer Square, Square Jack w/ Footplate # MJSQ-2500B which is also rated at 2,500 lbs. I attached a review video of this jack for you to check out.
Product Page this Question was Asked From
Fulton Square, Fixed-Mount Marine Jack - Drop Leg - Sidewind - 30" Lift - 2,500 lbs
- Trailer Jack
- Boat Trailer
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Marine Grade
- 2001 - 3000 lbs
- Manual Jack
- 30 Inch Lift
- Bolt-On
- With Rectangle Foot
- Fulton
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Looking For Replacement 7-Way Plug With Double Prong Design
- Q&A: Will a Taller Drop Leg Fit Fulton 2.5K Square Fixed-Mount Marine Jack FHD2500
- Q&A: Does Grease Seal # 34823 Feature a Garter Spring
- Q&A: 12 Volt Accessory Circuit Relay Location in 2019 Ford F-250
- Q&A: Troubleshooting Weak Trailer Brakes That Won't Lock Up with Override Lever of Controller Slid
- Q&A: How Can I Replace Lippert Unity X1 Control Board Part 801171
- Q&A: Solution for Brake Actuator on 3-1/2" Trailer Tongue
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure a Trailer Axle