How Tight Should the Castle Nut be When Installing a Trailer Hub or Hub and Drum Assembly
Published 10/26/2017
Question:
What is the porper Torque spec for the hub nut? Does it go to a certain torque and then is it backed off a certain amount? I am installing all new bearings also. I usually would spin the assembly as I am tightening to properly set the bearings. If you have a different procedure let me know.
asked by: Vince M
Expert Reply:
What our installers do is tighten the castle nut with channel locks then back it off. He does this several times to ensure it is all the way on then backs it off one notch to the next nearest slot for the pin or tang washer. I have linked an installation video below showing this.
Product Page this Question was Asked From
Dexter Trailer Hub and Drum Assembly for 3,500-lb Axles - 10" Diameter - 5 on 5 - Pre Greased
- Trailer Hubs and Drums
- Hub with Drum
- Pre-Greased
- L68149 / L44649
- Standard Grade
- For 3500 lbs Axles
- 5 on 5 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement For A Dexter 8-249 Hub And Drum Assembly
- Q&A: Replacement Brake Assemblies for Dexter 3,500 lb Trailer Axle
- Q&A: Comparing the Kenda Karrier and the Maxxis M8008 225/75R15 Size Tire
- Q&A: Comparing the eTrailer and Dexter Electric Trailer Brake Kits
- Q&A: Availability of Dexter Axle Brake Assemblies K23-026-00 and K23-027-00
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Torque Specs for 3500-lb 5-on-4-1/2 Dexter Hub/Drum 84546UC3
- Article: Adding Electric Over Hydraulic Disc Brakes
- Q&A: Mounting Bolt Pattern on etrailer.com Electric Brake Kit # AKEBRK-35-SA
- Article: Trailer Wiring Diagrams
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer