Backup Camera of Rear View Safety Backup Camera System
Updated 10/13/2017 | Published 10/12/2017 >
Question:
I wish to install this system on my trailer. Can I put a plug in the camera cable going to the vehicle? When I disconnect my trailer I will need to unplug the camera that is on the back of the trailer.
asked by: Wayne
Expert Reply:
You would be able to put a plug at the end of the power cord to the backup camera on the Rear View Safety Backup Camera System # RVS-770613-112 if you would like. There is nothing specifically made to do this however, and you should be able to disconnect your trailer and unplug the camera without needing to put a plug on the end of any cables as they will be protected from the elements while in your trailer.
Product Page this Question was Asked From
Rear View Safety Backup Camera System with Rear Sensors
- RV Camera System
- Backup Camera
- Mirrored Image
- Night Vision
- Hardwired
- Wide View
- Dashboard Pedestal Mount
- Rear
- 7 Inch Display
- 1 Camera
- Rear View Safety
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement for Firestone Air Compressor 24-3582-9210
- Q&A: Can the Furrion Camera System with Marker Lights Be Used On Trailer with LED Side Marker Lights
- Q&A: Dexter 10,000LB Axle Wheel Retaining Ring Placement
- Q&A: Recommended Air Pressure for Provider HD ST235/80R16 Radial Trailer Tire
- Q&A: Will the Bolt-On Shock Kits for Trailers Work With Underslung Axles
- Q&A: What is the Right Replacement Monitor for My Rear View Safety RVS-770613N?
- Q&A: Looking For Lock Cylinder 509 On T-Handle
- Article: Can You Flat Tow a 2024 Chevy Colorado?
- Article: Brake Controller Installation: Starting from Scratch
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?



