Looking For Lock Cylinder 509 On T-Handle

Question

Question:

UWSLOCKCH509 Looking for t handle with 509... cant seem to find it

asked by: Armando

0

Expert Reply:

The only lock cylinder we have that is 509 is the Replacement Lock Cylinder for UWS Toolboxes w Square Paddle Handles - CH509 # UWSLOCKCH509. We also have extra keys available. They are the Replacement Key for UWS Toolboxes - CH509 # KEYCH509. Unfortunately this won't help with a locking t-handle.

The only T-handle lock we currently carry is the Camco Replacement Locking T-Handle - 2-1/4" Long x 5/16" Square Shaft # CAM44393, so you may want to consider swapping your current locks out.

expert reply by: Jason S

0

click to enlarge

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 5

Thanks for reaching out, Tom! The answer pages you're looking at are actually referring to 2 different T-Handles: - Locking T-Handle #37210985 (1/4" Square Shaft and Mounting Holes 1-5/8" apart) - Camco Replacement Locking T-Handle…

view full answer...

Answer 6

Hey Robert, thanks for reaching out! We don't have replacement keys, but we do have replacement handles/locks like the Bauer Products #BA77VR which has the mounting holes spaced 1-1/2" apart on center. If this doesn't look like what you…

view full answer...

Answer 7

Although there are no wiring diagrams available for the #PK11501, when looking at the front of the harness the 12 o'clock pin is the tail lights (brown wire) the 2 o'clock pin is the aux circuit (red), the 5 o'clock pin is the right…

view full answer...

Answer 8

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Looking For Lock Cylinder 509 On T-Handle

Products Featured in This Question

Continue Researching