Can Handle on 3K Square Direct Weld Jack with Footplate TJD-5000S be Easily Removed
Updated 09/19/2017 | Published 09/18/2017
Question:
Is it removable? If so, how hard is it to remove.
asked by: Thomas B
0
Expert Reply:
The handle for Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 15-1/4" Travel - 3,000 lbs Item # TJD-5000S can be removed but it isn't easy. You would have to take the top cap off and then drive out a roll pin and/or clips holding the handle in one of the gears. If it isn't something that you have to do you will probably want to avoid removing the handle. The same goes for any trailer jack.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 28-3/4" Lift - 3,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Sidewind Jack
- 2001 - 3000 lbs
- Manual Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What is Outer Tube Diameter of Trailer Valet Jack # TV57ZR
- Q&A: What is Overall Height of etrailer Jack # e34RV When Fully Retracted
- Q&A: Replacement for a Triple Vision Backup Camera and Monitor
- Q&A: Need Replacement For UFP PG1090 Actuator On Magic Tilt Single Axle Trailer
- Q&A: Timbren SES for 2021 Nissan Frontier Hauling Commercial Mower and Towing Utility Trailer
- Q&A: Can Spacers Be Added to Timbren SES To Make Smaller Gap
- Q&A: Axle Hub That Uses Bearings JM511946 and JM205149, Race JM511910 and JM205110
- Article: Trailer Lighting Requirements
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Jacks