Will the Curt Class lll Trailer Hitch for 2010 Ford Explorer Fit with Factory Hitch and Spare Tire
Published 05/02/2011
Question:
2010 Ford Explorer Mine is a four door model with the large spare tire and class 2 hitch all ready made on the frame will the Curt part # 13112 fit on corectly with the full size spare tire. and if not what hitch will ?
asked by: Wade H
Expert Reply:
Yes, the Curt Class III Trailer Hitch, item # 13112, will fit on your 2010 Ford Explorer, with factory 1-1/4 inch hitch. Since your vehicle is equipped with the factory hitch you cannot use both hitches at the same time, damage to the hitch or vehicle would result.
You will reinstall the full size spare tire in the original location, should you find it necessary to remove it, to ease installation of the Curt hitch.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 8000 lbs WD GTW
- 2 Inch Hitch
- 800 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What Color is the Black Fade Replacement Fabric for etrailer Powered RV Awning e96QV When Rolled Up?
- Q&A: Looking for Replacement Lid for Ventline V2094 RV Roof Vent
- Q&A: Can Ball Mount be Used Upside Down to Use in Rise Position
- Article: How Much Solar Power Do I Need For My RV?
- Q&A: What is the Difference Between Load Range B and C Trailer Tires
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How To Install Trailer Brake Controller and 7-Way Trailer Connector on International 4300
- Q&A: Trailer Wiring Harness For A 2022 Volkswagen Taos
- Q&A: Can You Flat Tow A 2023 Subaru Crosstrek With A Manual Transmission
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller Installation: Starting from Scratch
- Article: 5 Things to Know About Weight Distribution Hitches