How to Extend the Wiring of a LT200 Superwinch # 1120210 on a 2005 Yamaha Wolverine 350 FX
Published 05/02/2011
Products Featured in This Question
Question:
The wiring for the Superwinch comes up about 12 short for the winch connections. What is the best way to extend the wiring leads? They look to be about a 10 or 12ga. Installing on 2005 Yamaha Wolverine 350 FX. Solenoid has been installed in the under seat tool box at the rear of the ATV. Wiring is running under RH side of frame. Thanks
asked by: Paul
Expert Reply:
The best way to extend the wiring would be to get 10 Gauge Blue Primary Wire, part # 10-1-1, to extend the wiring and then use a 12-10 Gauge Butt Connector, part # 05732-2, to connect the wires. And then finally wrap the connection with Electrical Tape.
That should give you the additional 12 inches you would need to connect your Superwinch LT2000 ATV Winch, part # 1120210, to your 2005 Yamaha Wolverine 350 FX.
I attached installation instructions for the # 1120210 below.
Product Page this Question was Asked From
Continue Researching
- Q&A: How Do You Install The Furrion Chill Single Zone Controller FACC12SA-BL?
- Q&A: Common Torque Specifications for Lug Nut Size
- Q&A: Butt Connector Recommendation for Wiring up Brake Assemblies on Trailer
- Q&A: Adding a 7-Way Trailer Connector and Brake Controller on a 2008 Toyota Tundra with 4-Way Connector
- Q&A: Recommended Hitch for a 2008 Toyota Tundra
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Valve Stem For 125-130 PSI And TPMS Sensors
- Q&A: What Gauge Wire Do The Dexter Electric Trailer Brakes 23-47-48 Use?
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Article: The 5 Best Trailer Drop Hitches You Can Buy