Routing Recommendation for Transmission Cooler # D13503 When Installing on a 2009 Chevy Silverado

Updated 04/22/2011 | Published 04/21/2011

Products Featured in This Question

Derale Series 8000 Plate-Fin Transmission Cooler Kit w/Barb Inlets - Class III - Efficient

(887)

$104.38

Derale Snap-In Radiator Adapter Fitting for GM

(275)

$16.69

Question:

I have ordered cooler # D13503 and adpater # 13035 for my 2009 Silverado. It has a cooler from the factory on it. When I add this cooler, do I hook it up to the return line from the factory cooler or do I hook this cooler so that the fluid comes through it first? Will the package come with instructions?

asked by: Terry W

Expert Reply:

Yes, you will want to route the factory cooler in the way that you described.

You would want to route the Derale cooler after the factory cooler. By that, I mean you would want to run the transmission coolant line from the transmission, to the factory cooler, then to the # D13503, and finally back to the transmission cooler.

Routing the coolers in that order is crucial, if you were to run the cooler before the factory cooler you would effectively be cooling the fluid and then reheating it as it would go through the factory cooler, which will be the same temperature as your engine coolant.

I attached an FAQ article on transmission coolers below for you to check out.

This product should have installation instructions included with it.

I attached an FAQ article on transmission coolers below for you to check out also.

expert reply by: Jameson C