Dimensions of the Replacement Protective Foam Pads for Hollywood Racks Trunk Bike Racks HR52
Updated 08/07/2017 | Published 08/04/2017
Question:
What is the inside diameter and outside diameter of the tubes and how long are each tube. Looking for replacement rubber bumpers for old rack. The bumpers that touch the paint are getting hard. the ones I want to replace are 3.5inch long, 1 3/4inch outside diameter and 7/8inch inside diameter hole
asked by: Dennis Y
Expert Reply:
I went out to our demo area to measure some Replacement Protective Foam Pads for Hollywood Racks Trunk Mounted Bike Racks - Qty 4 Item # HR52 that were already on a bike rack. The length is 2-3/4 inches. They are designed to fit around a 1 inch diameter tube. Once on the rack the outer diameter is 2 inches.
If these will not work you might have better luck trimming a pool fun noodle if nothing else will work.
Product Page this Question was Asked From
Replacement Protective Foam Pads for Hollywood Racks Trunk Mounted Bike Racks - Qty 4
- Accessories and Parts
- Trunk Bike Racks
- Pads
- Hollywood Racks
more information >
Continue Researching
- Article: Holiday 2025 | Best Gifts for RVing
- Q&A: What Is The Purpose Of The Magnets On The etrailer Magnetic Hitch Receiver Reducer Sleeve e28JR
- Q&A: Recommended Tonneau Cover that Sits Above Bed Rails for a 2024 Ford F-250 W/ a 6 1/2' Bed
- Q&A: Tips for Installing New Foam Pad # HRSPR-FP on a Bike Rack
- Q&A: Comparing Thule T2 Pro X vs Thule T2 Pro XTR
- Q&A: Replacement Wheel Strap for Thule T2 Pro XTR Bike Rack
- Q&A: Replacement Screws for Thule T2 Pro XTR Bike Rack for 2 Bikes
- Q&A: Length of T2 Fat Bike Replacement Straps/Troubleshooting Strap Not Being Long Enough