Only 1 LED Lighting Up with Opti-Brite RV Interior Strip Light w/ Switch # ILL70CBSBAWN
Updated 08/01/2017 | Published 07/29/2017
Question:
Why is only one led working I bought two lights and tjey both do the same thing cant figure it out
asked by: Erik W
Expert Reply:
The first thing to check on the Opti-Brite RV Interior Strip Light w/ Switch - Awning Mount - White LEDs - Black Housing Item # ILL70CBSBAWN is the ground wire. Make sure it is grounded to a clean bare metal surface. A weak ground could cause the light to not light up all the way.
An easy test would be to connect the light wires to a 12 volt battery. If it still does the same thing then there is a problem inside the lights and they will need to be replaced.
Product Page this Question was Asked From
Opti-Brite LED Strip Light w/ Switch for RV Awnings - Weatherproof - Black Housing - 11" Long
- LED Strip Lights
- Flexible Light
- Interior Light
- Awnings
- Hardwired
- 11 - 20 Inch Long
- Cool White
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Lights for RV With Lights Taking Water Damage
- Q&A: Replacement Light Bar Strip 2016 Northwood Artic Fox Camper w/ Mounting Holes 10-1/8" on Center
- Q&A: How To Remove Light Cover To Replace Screw
- Q&A: Replacement Converter For Progressive Dynamics PD4575K18L
- Q&A: Replacement Scissor Jack for 2014 R-Pod Camper
- Q&A: Recommended Replacement For A Lippert Coach Step Model # 168367
- Q&A: Submersible Amber Light
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Trailer Lighting Requirements
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Repair an RV Roof