Should 2002 Toyota Sequoia with Front End Lift be Level with AirRide Helper Springs Installed
Updated 07/31/2017 | Published 07/28/2017
Question:
My sequoia has a 2inch front end lift on it, with the AirRide 1000 on the rear, when they are pumped up should it be level when I pull my car trailer ? Thanks
asked by: Timmy C
Helpful Expert Reply:
When adjusting the air pressure for the Air Lift AirLift 1000 Air Helper Springs # AL60812, you will want to set them so your vehicle is as level as possible when pulling your car trailer. Even with the front end lift, your 2002 Toyota Sequoia will ideally lose any of the rear sag you previously experienced with the trailer coupled.
The springs themselves can be adjusted between 5 psi to 35 psi, depending on your application.
Product Page this Question was Asked From
Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Light Duty
- Rear Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does Bump Stop Need to be Cut Same Length on Firestone and Air Lift Springs in Toyota Sequoia
- Q&A: Brake Controller with Plug-In Adapter for 2020 Ram 1500 With Tow Package
- Q&A: How Does Curt TriFlex NEXT Brake Controller Mount
- Q&A: What is the Difference Between the Tekonsha Prodigy P2 and the P3 Brake Controllers
- Q&A: Replacement Bearings for Dexter 5k Axle on 2021 Forest River Rockwood Ultra Lite 2442BS
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Q&A: Correct Equal-i-zer Weight Distribution System for Winnebago Micro Minnie 1800BH
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Q&A: Air Lift Air Helper Springs Confirmed to Fit a 2002 Toyota Sequoia