If Wood is Secured to E-Track Bracket # 59149 Can Board be Removed as One Piece
Updated 07/26/2017 | Published 07/25/2017 >
Question:
If you secure the wood to the bracket can you remove the wood and bracket as one? Or would you have to unscrew the wood to allow the bracket to be removed from the wall?
asked by: Michael C
0
Expert Reply:
Since the bracket part # 59149 has to be angled into the E-track to install there wouldn't be a way to pull the board and bracket out of a track as one piece since the board would prevent you from getting the right angle.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
E Track Wood Beam Socket for Standard 2" Lumber - Qty 1
- E Track
- E Track Cargo Organizers
- Board Holder
- Erickson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Availability Of 2" Long 1/2" Wheel Stud With 0.56" Spline
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Using # 37185 Adapter to Provide 7-Way Trailer Connector on 2003 Ford Pickup
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Recommended Hitch for a 2023 Lexus RX 350
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Is E-track Stronger Than X-track, Is There An Advantage Of One Over The Other
- Q&A: E-Track System For Enclosed Trailer Walls
- Q&A: Can I Use the etrailer High-Low Fixed Adapter for Tow Bars e85ZV on a Boat Trailer?
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: How to Measure Your Trailer Wheel Bolt Pattern


