Installation Of The Weld On Titan Surge Brake Actuator # T2404600
Updated 07/12/2017 | Published 07/11/2017
Question:
just purchased a titan surge brake actuator t2404600 from you. The unit is a weld on coupler. Do I need to disassemble it to weld on to trailer.
asked by: Neals P
0
Expert Reply:
You do not need to disassemble the Titan Adjustable-Channel Brake Actuator - Painted - Drum - Weld On - 12,500 lbs # T2404600 to weld it. It is recommended to tack weld it in place and then complete the welding. You do want to remove the cap on your master brake cylinder until the unit cools down after welding.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Dexter Adjustable-Channel Brake Actuator - Painted - Drum - Weld On - 12,500 lbs
- Brake Actuator
- Surge Brake Actuator
- Construction Trailer
- Farm Trailer
- Weld-On
- 12500 lbs GTW
- Channel
- 3 Inch Channel Tongue
- Drum Brakes
- No Lockout
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Inner Slide for Titan Model 10 Actuator with 2-5/16 Coupler
- Q&A: Replacement Spindle Option for Mobile Home Axle
- Q&A: How Long Is Curt 7 Way Wiring Harness C69CR For 2020 - 2027 Ford Super Duty And Cab & Chassis Trucks
- Q&A: What Does KodaGuard Coating on Kodiak Disc Brakes Do
- Q&A: Replacement Option For Tie Down 80LP Actuator For Disc Brakes
- Q&A: Replacement 12" Hydraulic Drum Brake Replacements for a 1999 MasterCraft Boat Trailer
- Q&A: How Do You Know if a Trailer Brake Actuator Shock Needs to be Replaced
- Article: Trailer Lighting Requirements
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Trailer Maintenance Schedule
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: The 5 Best Trailer Drop Hitches You Can Buy