Will Both Sets of Bump Stops Need Trimming When Installing SuperSprings on 2006 Nissan Frontier
Updated 06/27/2017 | Published 06/25/2017
Question:
I am going to be installing SSA1 supersprings on a 2006 Nissan Frontier Nismo. I will be trimming the current bump stops to put down the brackets before the springs. Do I need to replace a small bump stop on top of the supersprings?
asked by: Mark
0
Expert Reply:
I consulted the installation instructions for the Sumo SuperSprings # SSA1MTKT, and on your 2006 Nissan Frontier the lower bump stops are the only set that will need to be trimmed.
There are no instructions of altering or replacing any upper bump stop when installing the spring to this vehicle.
expert reply by:
Jared P
0
Product Page this Question was Asked From
SuperSprings Suspension Stabilizer and Sway Control Kit - OEM Leaf Springs Above Axle
- Vehicle Suspension
- Towing/Load Leveling
- Leaf Springs and Helper Springs
- Suspension Only
- Helper Springs
- Light Duty
- Rear Axle Suspension Enhancement
- SuperSprings Intl
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can Safety Chain Retainer Be Mounted On Side Of Trailer Tongue
- Q&A: Recommended Brake Controller and Wiring for a 2022 Toyota Highlander
- Q&A: Recommended Weight Distribution Hitch for 2022 Keystone Springdale Mini 1750RD
- Q&A: Looking For Budget Friendly Weigh Distribution Hitch To Pull 5K Dump Trailer
- Q&A: Bearings For Older Trailer Hub 22834
- Q&A: What Happens if Hand Held Remote from Tekonsha Prodigy RF Unplugs from Power While Towing
- Q&A: Comparing Equal-i-zer and Curt TruTrack Weight Distribution Systems
- Article: Best Boat Trailer Jacks
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Measure for Trailer Hitch Drop