Should Air Lift 1000 Helper Springs Create a Lift When Not Inflated on 2012 Chrysler Town & Country
Updated 06/19/2017 | Published 06/16/2017
Question:
2012 Chrysler Town and Country Touring. Installed this and love it... is it normal to have a lift in bumber height of 2-3 inches from before install? No complaints... I actually love the added height. Tried with 5 psi or 30 psi... either way there is a lift effect from before adding these bags.
asked by: Jeremy B
Helpful Expert Reply:
Chances are you were sagging a little below stock before you installed the AirLift # AL60814. I reached out to my contact at Air Lift and they agreed that you have nothing to worry about.
Product Page this Question was Asked From
Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Light Duty
- Rear Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How Much Truck Sag Is Too Much? | Suspension Fix Guide
- Q&A: Rear Helper Spring Recommendation for a 2009 Dodge Grand Caravan
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Q&A: Curt Trailer Hitch Installation Instructions for a 2012 Dodge Grand Caravan
- Article: Performance Chips and Modules
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Q&A: Recommendation To Reduce Rear End Squat on a 2024 Nissan Rogue When Carrying Hitch Cargo Carrier
- Q&A: Will Adding a Vehicle Suspension System Lift my 2012 Dodge Grand Caravan When Carrying Cargo
- Q&A: Increasing Clearance on Rear of Chrysler Town and Country with Steep Driveway
- Q&A: Can Weight Distribution and Suspension Enhancement be Used with 2008 Toyota Highlander
- Q&A: SumoSprings Helper Springs For a 2023 Toyota Highlander Limited Platinum
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)